Swapping fill valve awkward pipework

Joined
16 Jul 2009
Messages
911
Reaction score
6
Location
Hull
Country
United Kingdom
Could any one give advice on there ideas if swapping this fill valve is 3/8 male thread to a 1/2 male thread one. It's an awkward pipework configuration. The Flexi that is in at the moment is bent/kinked over. Thanks
 

Attachments

  • IMG20211213134628.jpg
    IMG20211213134628.jpg
    158 KB · Views: 91
Sponsored Links
How in line is that ISO with the valve? Can you not get a small pipece of pipe and a tap connector onto it? I'd also be tempted to knock that little piece of time out to get it all to line up and then as above.

The alternative would be to remove the piece of pipe/elbow, use a flexi onto the ISO and pigtail it.
 
It's out of line could maybe with a street elbow and elbow. Ok I may try that chip abit of tile out to get it to line up. Thanks
 
Sponsored Links

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top