Hi there. Ok, following on from my post about the SWA abbreviation, here's the project that gives rise to that question.
In short, I want to connect this
View media item 26911
To this:
View media item 26912 View media item 26913
I am planning on using 6mm 3c SWA.
The demand side of the project will be a few fridges/freezers and the occasional use of electric hand tools.
There will be two lighting circuits with two fluorescent tubes, and six 13 amp double sockets.
The three MCBs on top of the Wylex consumer unit date from another project, and so I am intending to replace them/check that they are applicable for my needs.
In short, I want to connect this
View media item 26911
To this:
View media item 26912 View media item 26913
I am planning on using 6mm 3c SWA.
The demand side of the project will be a few fridges/freezers and the occasional use of electric hand tools.
There will be two lighting circuits with two fluorescent tubes, and six 13 amp double sockets.
The three MCBs on top of the Wylex consumer unit date from another project, and so I am intending to replace them/check that they are applicable for my needs.