- Joined
- 2 Apr 2017
- Messages
- 6
- Reaction score
- 0
- Country
Guys, help I am struggling a little wiring an Impaq Plus with magnetic contact to a Texecom 48 panel. I am getting a resistance change on the shock zone1, however its not going to an active state only staying as secure, and I am not getting anything from the contact zone2, its stuck in an active state despite playing with the magnet position. Would someone mind sanity checking my setup, please.
Impaq - Cable Colour - Panel
Reed - Brown - Z2 Alarm
Reed - Orange - Z2 Alarm
Latch - unwired
Tamp - White - Z1 Tamp
Tamp - Green - Z1 Tamp
Alarm - Blue - Z1 Alarm
Alarm - Yellow - Z1 Alarm
0v - Black - 0v Aux
12v - Red - 12v Aux
Panel Z2 Tamp 1 & 2 not wired to anything ??
Z1 - Guard - Normally closed
Z2 - Entry/Exit 1 - Normally closed
Any assistance would be much appreciated, been banging my head against the wall for the last few hours on this one. I did do a bit of searching and was able to find that i need to link Zone2 tamp out, but not sure out to where?
Thanks, James
Impaq - Cable Colour - Panel
Reed - Brown - Z2 Alarm
Reed - Orange - Z2 Alarm
Latch - unwired
Tamp - White - Z1 Tamp
Tamp - Green - Z1 Tamp
Alarm - Blue - Z1 Alarm
Alarm - Yellow - Z1 Alarm
0v - Black - 0v Aux
12v - Red - 12v Aux
Panel Z2 Tamp 1 & 2 not wired to anything ??
Z1 - Guard - Normally closed
Z2 - Entry/Exit 1 - Normally closed
Any assistance would be much appreciated, been banging my head against the wall for the last few hours on this one. I did do a bit of searching and was able to find that i need to link Zone2 tamp out, but not sure out to where?
Thanks, James