Right external Sounder box ... has 3 x 3 pin jumpers to configure, marked as follows.
[code:1]
ON ON
. .
|
. | |
JP1 JP2 JP3
[/code:1]
JP1 = Battery (ON/shorted)
JP2 = SAB (bottom two contacts shorted)
JP3 = LP (lower power, botton two shorted (i.e. high power)
So, issue is I think middle is if i have 2 sounders, BUT i only actually have 1. Its not clear which pins is the right one to have one SAB. Can anyone advise on right seetting for middle pin (JP2) with only 1 sounder?
[code:1]
ON ON
. .
|
. | |
JP1 JP2 JP3
[/code:1]
JP1 = Battery (ON/shorted)
JP2 = SAB (bottom two contacts shorted)
JP3 = LP (lower power, botton two shorted (i.e. high power)
So, issue is I think middle is if i have 2 sounders, BUT i only actually have 1. Its not clear which pins is the right one to have one SAB. Can anyone advise on right seetting for middle pin (JP2) with only 1 sounder?