Hi Everyone,
I have an electrician install a Texecom Premier 24 panel. Being an IT buff, I thought, how hard can it be to program it...!!! (I can see you all smirking..!)
So, now its come to the point I need help. It was mainly all factory defaults. I used the manuals and managed to do the obvious bits, like set the codes and add users with their names etc...
FYI: I am running a:
Texecom Premier 24
6 Zones
2 Keypads.
The main issue is when I set the alarm. The keypad is in the hallway as is my Hallway sensor (Zone 1).
When I set the alarm, Zone 1 can see me and it picks me up. This is currently set to Zone Type; Entry/Exit 1.
For some reason, around 50% of the time, it comes up with "Zone Arm fail" and I get an internal alarm - it feels like the alarm is just ignoring the zone type of the hallway sensor, gets to the 15 second countdown, realises that someone is there and decides to "Arm fail".
No other sensors can see me when I am entering the code... i.e. The living room or kitchen. If I do decide to walk into one of those rooms when I have set the code, the alarm activates immediately.
Any thoughts on the Hallway countdown / Zone type issue...!!!
Help!!
Thanks
I have an electrician install a Texecom Premier 24 panel. Being an IT buff, I thought, how hard can it be to program it...!!! (I can see you all smirking..!)
So, now its come to the point I need help. It was mainly all factory defaults. I used the manuals and managed to do the obvious bits, like set the codes and add users with their names etc...
FYI: I am running a:
Texecom Premier 24
6 Zones
2 Keypads.
The main issue is when I set the alarm. The keypad is in the hallway as is my Hallway sensor (Zone 1).
When I set the alarm, Zone 1 can see me and it picks me up. This is currently set to Zone Type; Entry/Exit 1.
For some reason, around 50% of the time, it comes up with "Zone Arm fail" and I get an internal alarm - it feels like the alarm is just ignoring the zone type of the hallway sensor, gets to the 15 second countdown, realises that someone is there and decides to "Arm fail".
No other sensors can see me when I am entering the code... i.e. The living room or kitchen. If I do decide to walk into one of those rooms when I have set the code, the alarm activates immediately.
Any thoughts on the Hallway countdown / Zone type issue...!!!
Help!!
Thanks