Texecom Premier Elite 24 Alarm System

[trev_may]

Hi, I have installed the Texecom Premier Elite system and not able to arm. I get the following message ‘Area in Exit > A’
The set up is basic and has 4 x PIR’s, 1 x Door Switch & 1 x Panic Switch. The Entry exit Zone is A PIR rather than a door contact.
I’m not seeing a ‘Ready Light’ which I understand has to be on to allow for arming.
The installation used existing cables and PIR’s. I have also conducted a walk test and all checks out.

Any ideas would be very much appreciated.

Many thanks.

 

[sparkymarka]

What is A setting type ….entry/exit or timed ….needs to be timed

 

[trev_may]

Hi,

Many thanks for your reply.

Pardon my ignorance - does A refer to zone 1 which in my system is the entry/exit (PIR). What menu function do I access and change to ‘Timed’ ?

Also could I clarify the status of the control box LED ( visible through the cover). I understand this light should be solid for the Texecom Premier system and should flash for the Premier Elite 24 system. Is this correct?

Once again, many thanks

 

[sparkymarka]

All your devices will be area A , go into engineer programming , go to area programming , arming modes , area A arm by …default is exit ….change to timed …

 

[trev_may]

Perfect!!! All works fine.

Thank you so much for your help