Texecom Premier Elite and Pyronix Twin Alert

Joined
12 Dec 2014
Messages
7
Reaction score
0
Location
London
Country
United Kingdom
So i've searched the forums and found how the twin alert should be wired.

Tamper > Spare Zone
BA > Bell
SPK > SPK-
-12v > -Aux
+12v> Bell 12v

The bell function works fine, however the speaker is refusing to work, both in test mode and when arming / disarming etc.

Any ideas what might be wrong?

Thanks in advance.
 
Sponsored Links
there is a speaker volume control pot on the twin flex check it isn't turned down its near the tamper switch
 
Thanks - but unfortunately that doesn't make a difference.
 
You might need a 2k2 pull up resistor across the 12v+ and the spk terminals
i could also be to do with the L1 and L2 jumpers i think the texecom speaker output is -v applied
 
Last edited:
Sponsored Links

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top