Texecom user access timer con

[cjp2k]

Hi all, I am trying to set one user to only have access to the alarm one day a week. I have set control timer 1 Time A to the days where I don’t want the user to have access (including today) and set user locker by control timer 1

The panel has 2 areas which the user who I want to limit access to can only disarm area a

When I type the code for the user in, it just says welcome and allows both arming and disarming

Any ideas what I am doing wrong

 

[secureiam]

Timer needs at least 5 minutes clear, so if you locked it out for 10pm today, then you would need to have it set up before 9.55pm but don’t see your programming so can’t be certain anything else is right or wrong.

Most common error is not allowing if enough time

 

[cjp2k]

Thanks I’ve set it from midnight, so I will try again tomorrow

 

[secureiam]

in terms of testing, to make sure you have it programed correctly I would set it for in 10 minutes time, then you can test and retest until you know you have it correct, then set for the times you want it to work for.

 

[cjp2k]

just an update it’s working today, yesterday I was setting a start time that had already happened, all working now, just to test on Thursday to ensure it works at expected

 

[secureiam]

Yeup start time for testing needs a few minutes so always recommend testing by setting up for 10 minutes in the future.

The. Program in the actual times you want