- Joined
- 29 Aug 2020
- Messages
- 99
- Reaction score
- 5
- Country
Has anyone replaced a bath panel on a corner bath with tongue and groove ?
Is so is it very difficult?
Many thanks
Is so is it very difficult?
Many thanks
Sounds interesting, is it hard to work with ?Uvpc t&g , waterproof and in many colours .
Very easy .Very cheap .Sounds interesting, is it hard to work with ?
Roofing , uvpc suppliers, builders merchants ( Selco, Wickes stock).Where do you buy that plastic?
That’s why you rip the back cells so it’s only a thin sheet to bend.the trouble you have with plastic when you try to bend it the back wall can concertina on one or more sections and you then get a crease at the front where it changes angles
I cut every one , no problem, still plenty of resistance.indeed but better to cut perhaps every third or fourth to give a gradual angle change as if you cut too many there is little or no resistance to folding near to flat causing a virtually uncontrolled reduction in outer surface form ??
thanks for the feed back very helpfulI cut every one , no problem, still plenty of resistance.
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local