We are about to have some new aluminium windows installed. These windows will be fitted with two electric openers per window
This is the sort of opener. There will be two motors operating a single window. There will be a YT2 plastic trunking running left to right on the horizontal transom to contain the motor flexes.
There will be a flush mounted FCU on the wall located where the green circle is, with a conduit to take the wiring into the ceiling void.
I need some sort of accessory to install where the red circle is on the window reveal to terminate the trunking into and then allow me to run into the FCU with flush mounted conduit or kopex. Ideally it would be a flush accessory with room to joint the flexes inside.
Any body got any great ideas? I’ve thought about just a flush box with a blank plate but it doesn’t seem very elegant and it’s a bit difficult to properly transition from trunking in to it.
This is the sort of opener. There will be two motors operating a single window. There will be a YT2 plastic trunking running left to right on the horizontal transom to contain the motor flexes.
There will be a flush mounted FCU on the wall located where the green circle is, with a conduit to take the wiring into the ceiling void.
I need some sort of accessory to install where the red circle is on the window reveal to terminate the trunking into and then allow me to run into the FCU with flush mounted conduit or kopex. Ideally it would be a flush accessory with room to joint the flexes inside.
Any body got any great ideas? I’ve thought about just a flush box with a blank plate but it doesn’t seem very elegant and it’s a bit difficult to properly transition from trunking in to it.