I have a Veritas 8 Alarm unit.
The unit has been working well for years.
Recently we have a single beep coming from the system.
When we set Full or part the system goes through the motion of setting. Then it beeps to indicate that a door has opened and then the main alarm gies off if youdo not enter code.
When not set we hear a single beep pause and a single beep. This is repeated , according to forum dingle beep means zone 1. We checked and all ok. Door open or close the chime happens. So zone 1 working.
Beep is heard only on 1 keypad out of 3.
So any ideas.
The unit has been working well for years.
Recently we have a single beep coming from the system.
When we set Full or part the system goes through the motion of setting. Then it beeps to indicate that a door has opened and then the main alarm gies off if youdo not enter code.
When not set we hear a single beep pause and a single beep. This is repeated , according to forum dingle beep means zone 1. We checked and all ok. Door open or close the chime happens. So zone 1 working.
Beep is heard only on 1 keypad out of 3.
So any ideas.
