- Joined
- 20 Nov 2010
- Messages
- 229
- Reaction score
- 20
- Country
So I have two r8, one installed in the house, the other the garage. Garage one is much older is covered in grime and grot. Still works fine. One in the house, once powered up, goes into startup, I try to enter the code(incorrectly I've forgotten)/and is quickly pops the transformerv fuze. The house alarm has an ext keypad and bellbox on the front.
I've ordered a load of the small fuss to check the system, any tips to check? I was thinking isolate the bellbox first, it's outside so likely to leak, then the pirs and the door switch.
Is there a manufacturer reset so I can get a new code somehow?
I've ordered a load of the small fuss to check the system, any tips to check? I was thinking isolate the bellbox first, it's outside so likely to leak, then the pirs and the door switch.
Is there a manufacturer reset so I can get a new code somehow?