• Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.

Veritas v8

what did you do to get the walk test up?

code prog (all lights illuminated) 06
code 00 (all lights illuminated) 06
 
So would you say loop the tamp then link blue and yellows like the diagram in zones 3 , 4, 5?
 
I would remove the blue and yellow
link the tamp with a piece of cable/ staple
blue and yellow in zone 3(for zone 1 device)
blue and yellow in zone 4(for zone 2 device)
 
when you put in engineers mode did you

type engineers code prog (all lights illuminated) 06
type engineers code 00 (all lights illuminated) 06

if you don't get the lights illuminated after prog or 00 your not in the right place to enter 06
 
0v & Tamp is there a loop of wire? If not there is your problem.

Picture not too good so can't tell

This Tamper loop HAS to be made, sounder not fitted there will be a tamper fault.
 
Last edited:
Right its all working except the wiring to the box. Not sure which wire goes where in the bell box manual shows how to wire the alarm side but the bell box it doesnt
 
I've just had another quick look at your picture, the mains connections.

I suggest they are remade as there are bear wires showing, very dangerous, they should be fully in the connector.
 
Europlex,
Just done that to tidy everything up just my bell box to sort now and thank you.
Mick
 
Only thing i have noticed is when you set alarm strobe flashes but when the alarm is triggered it doesnt flash is it supposed to do that??
 

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top