washing machine hose blanking connector

[ETAF]

i have to disconnect a washing machine hose tomorrow - to have some flooring fitted
it does have an isolator - BUT just in case it does turn OFF completely - looking for something to either put on the hose connection at the washing machine end - or i take the hose off the isolator and connect something to that

i have various 15mm & 22mm blanking connections , i used on CH valves recently
and the blanking plates that come with rads -

I suspect i need some sort of Tap size , trying to see what the hose is in spec at screwfix was looking for

3/4" BSP (British Standard Pipe) thread male plug for the w/m end
or would the isolator connection be 3/4" BSP - so female on that i guess

hose end - which i would prefer

https://www.screwfix.com/p/flomasta-male-flanged-plug-3-4-x/22863

Made4Trade Brass Flanged Plug

• The only compression fittings range manufactured in the UK• Create a mechanical heat free connection• Suitable for use on both gas and water• Suitable for Domestic and Commercial Heating and Plumbing Applications• 25 Year Warranty • Manufactured to EN1254

www.toolstation.com

isolator end

Flomasta BSP Blank Nut 3/4" x - Screwfix

Order online at Screwfix.com. Brass blank nut. FREE next day delivery available, free collection in 1 minute.

www.screwfix.com

is that right or what do i get tomorrow

 

[cross thread]

Yes 3/4 BSP cap fit on the tap ,don’t forget a sealing washer

 

[ETAF]

Thanks for the fast reply

I probably be better at the washing machine end - so use the plug with PTFE tape on ?
i will probably get both as only a few quid - so may need a sealing washer the 15mm i have came with a washer tab

these the seals

https://www.screwfix.com/p/arctic-hayes-delta-tap-washers-3-4-5-pack/6169j

Ballvalve Washer, Rubber

www.toolstation.com

 

[Hugh Jaleak]

A 3/4" washer in the Cap will suffice. PTFE isn't designed for that type of joint.

 

[ETAF]

ok thanks

i'll get

Made4Trade Brass Flanged Plug

• The only compression fittings range manufactured in the UK• Create a mechanical heat free connection• Suitable for use on both gas and water• Suitable for Domestic and Commercial Heating and Plumbing Applications• 25 Year Warranty • Manufactured to EN1254

www.toolstation.com

Pillar Tap Washer

www.toolstation.com

and disconnect at the W/M end and use that on the hose part

 

[ETAF]

the tap worked fine and isolated the water - so i did not need the items
I purchased and used the plug anyway
and some spare hose washers - probably replace the one in there - as its about 7 years old now

thanks for the replies