Wera Click-Torque C1

[SammyInnit]

Can anyone recommend this? I've been using Wera tools for a while and I do have their 1/2" hammer ratchet which is nice but it was expensive. The C1 is even more so.

Would anyone recommend any other torque wrenches?

 

[SammyInnit]

I've changed my mind, would cost far too much to have a few of these to have a good range. Anyone used the draper TWs?

 

[Astra99]

Have a look at Machine Mart (www.machinemart.co.uk) and check out the Clarke range of torque wrenches.

 

[scbk]

If it's just for occasional use, I think any torque wrench from a known brand would be fine. I've got a draper one, does the job as far as I can see

 

[Burnerman]

Halfords 2001 range for around £80 - calibration service available too.
(Not that I've ever had mine done )
John

 

[^woody^]

Look out for the Aldi one that comes on offer now and again.

 

[Burnerman]

Lets hope they are better than some try squares I bought from there - excellent for marking out right angles at 88 deg
The vernier caliper was useless too.
John