WF541 Technical manual

[Ticktock58]

Hi, Just got a second hand WF541 washer and have no conditioner water. Can anyone advise me where I can get hold of a technical manual? I would like to be able to understand the flashing lights. When they start that is. Cheers.

 

[rocks1]

f01 light 4, motor triac
f02 light 3 motor, jammed/ tacho
f03 lights 3&4 Ntc fault
f04 light 2. pressure sw stuck on empty
f05 lights 2&4, pressure sw stuck on full
f06 lights 2&3, N/A?
f07 lights 2&3&4 heater relay
f08 light 1. heater relay
f09 lights 1&4 eprom/setup error
f10 lights 1&3, pressure switch not sensing
f11 lights 1&3&4, pump/draining error
f12 lights 1&2, communication error
f13 lights 1&2&4, dryer ntc/ fan motor
f14 lights 1&2&3, dryer heater
f15 lights 1&2&3&4, dryer heater relay
f16 N/A
f17 light 4, door lock
f18 light 3 comms error (3 phase motor) power board

f1 and f17 share the same light in your one error fo1 pcb gone ex pcb from here http://www.emwelec.co.uk/index.php?action=category&id=1


Read more: http://www.diynot.com/forums/viewtopic.php?t=179517#ixzz1eTZ20k5m

 

[Ticktock58]

Thanks rocks1. Do you never rest?

How do I sort out which light is which?

I am trawling throught the earlier posts in case it is already there. If so apologies.

I have noted http://www.emwelec.co.uk who do seem a good setup. I hesitate to ask them for a manual as they seem to be electronic parts only.

 

[rocks1]

Left hand side of the consol panel is 5 lights. They go like rinse hold mini load ect. Top one is number 1 bottom is 5 That's the lights then follow the chart. You won't get a tec manual but you could ask emw.