Whats this wire?

With trepidation ...........
All posts refer to disconnecting the green wire from the socket and thus causing an earth/bonding problem for that area, however, the OP mentions that the green wire goes back to a JB. The disconnected wire could be the earth for the circuit fed by the JB.
Suggest that, although the OP needs help, s/he should reconnect the green until a proper examination can be made.
 
Here I believe I found the issue, the loft has a socket for a light to run off it. as you can see is a old plug so is going to get replaced tomorrow ...

View media item 55797
That looks like a good old MK socket.

Personally, unless it's damaged then I'd leave it there - it will almost certainly be of "better quality and construction" than many modern replacements.
In fact, we have an extension lead with one of those on a small piece of wood at one end, and the matching plug from the period on the other. It's been in service as long as I can remember (well, almost certainly longer). In fact, there's a good chance it was made at the same time as the "long lead" which is a double version of that mounted on a wooden cable drum - I know for a fact that that one is older than me, and was made to allow dad's old electric mower to reach down the garden where they lived before I was around which was (IIRC) a couple of hundred feet long.
Must have been pretty good quality (rubber covered) cable as well, as that's still in good condition.
 
I know for a fact that that one is older than me, and was made to allow dad's old electric mower to reach down the garden where they lived before I was around which was (IIRC) a couple of hundred feet long.

I was expecting a couple of hundred years ago! :D
 
Them old MK sockets are open backed and so the terminations are backing right onto the wood a combustible material.
I've removed several of them from a house I'm working on recently all mounted right on the skirting board !
 
Just like those open backed batten lamp holders you always find in people's lofts. One to watch out for on EICRs...
 

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top