Hi folks, new to the forum.
Just moved house and have nearly finished gutting and renovating it.
Boiler is Kettling so decided to buy some sludge remover.
It's a glow worm 24hxi, and coming from a combi house to this 'sealed system?' ( cold water tank in loft, hot water tank in eaves, boiler in kitchen) I'm struggling to make heads or tales of it.
I turned off the boiler, turned the thermostat on the radiator to 0 and cracked her open. It doesn't stop!! No loss of pressure after 10 mins open.
I decided to go have a look for the filling loop at the boiler and as far as I can see there isn't?
How do I drain the system, then repressurize?! NIGHTMARE
Any and all help or suggestions appreciated!
Dan.
Just moved house and have nearly finished gutting and renovating it.
Boiler is Kettling so decided to buy some sludge remover.
It's a glow worm 24hxi, and coming from a combi house to this 'sealed system?' ( cold water tank in loft, hot water tank in eaves, boiler in kitchen) I'm struggling to make heads or tales of it.
I turned off the boiler, turned the thermostat on the radiator to 0 and cracked her open. It doesn't stop!! No loss of pressure after 10 mins open.
I decided to go have a look for the filling loop at the boiler and as far as I can see there isn't?
How do I drain the system, then repressurize?! NIGHTMARE
Any and all help or suggestions appreciated!
Dan.