I inherited what I now believe to be an ADT alarms system with my home; a SCANTRONIC 9800 system. Due to various works around the home I disconnected the system some years ago. I did myself a wiring diagram and so have all the termiantions noted with the exception of the outdoor sounder and beacon (SAB). From my investigations, this is an ELMDENE module although I do not know the model number.
There were 4 cables from my 9800 panel wired to the ELMDENE device, these are screened on the PCB as TR(yellow) 0V (black) 12V (red) and BELL (blue).
The ELMDEENE SAB has the following designations, +H, -H, RTN, -R, ENG, BATT and ST-. There is also a small link, hardwired from the PCB, I believe the other end of this link wires into the ENG terminal to stop the sounder when commissioning the system?
Can anybody advise me on the interconnections between the two modules?
I currently have the whole system wired in my living room whilst I try to familaries myself with the system. I note that I currently have no battery connected, I will need to puchase a new one ASAP.
Help/Advice will be very much appreciated
There were 4 cables from my 9800 panel wired to the ELMDENE device, these are screened on the PCB as TR(yellow) 0V (black) 12V (red) and BELL (blue).
The ELMDEENE SAB has the following designations, +H, -H, RTN, -R, ENG, BATT and ST-. There is also a small link, hardwired from the PCB, I believe the other end of this link wires into the ENG terminal to stop the sounder when commissioning the system?
Can anybody advise me on the interconnections between the two modules?
I currently have the whole system wired in my living room whilst I try to familaries myself with the system. I note that I currently have no battery connected, I will need to puchase a new one ASAP.
Help/Advice will be very much appreciated