Been looking for a lathe this last few weeks thought i could mabe make some air conditioning pipe fittings & mabe the odd agri shaft.
So i was thinking around 500mm - 1000mm between centers .
Been looking at Warco, Axminster, Meyer, all around the 3.5k mark
also enquired about a Colchester but £11700 + vat made me gulp then say ok i will think about it
Anyway i have agreed to purchase a 2nd hand Axminster ex school use if as good as described £1500 8 year old all the tools.
Can anyone advise on any faults to look out for.
viewing next week
So i was thinking around 500mm - 1000mm between centers .
Been looking at Warco, Axminster, Meyer, all around the 3.5k mark
also enquired about a Colchester but £11700 + vat made me gulp then say ok i will think about it
Anyway i have agreed to purchase a 2nd hand Axminster ex school use if as good as described £1500 8 year old all the tools.
Can anyone advise on any faults to look out for.
viewing next week