Hi All
Wylext consumer unit mounted on wall up against ceiling in a ground floor flat. Then two large rectangular knock outs have been removed out the back for cables to pass through.
The wall is plaster board (dot and dab) and the plaster board had been removed completely where these knock outs are. I’m concerned this will pose a enhanced risk if there was a fire within the consumer unit or am I overreacting?
Any ideas on how best to fix this with minimal disruption?
Thanks
Wylext consumer unit mounted on wall up against ceiling in a ground floor flat. Then two large rectangular knock outs have been removed out the back for cables to pass through.
The wall is plaster board (dot and dab) and the plaster board had been removed completely where these knock outs are. I’m concerned this will pose a enhanced risk if there was a fire within the consumer unit or am I overreacting?
Any ideas on how best to fix this with minimal disruption?
Thanks