Nearly there mate
Workshop Mk2
- Thread starter i_am_fubar
- Start date
Thanks Andy. Though I fear the end is far away still. But....
The door is in and glazed
And I have the insulation for the exterior walls
The flashing is all in around the foundation insulation. Clearance is clearance is clearance I guess?
The door is in and glazed
And I have the insulation for the exterior walls
The flashing is all in around the foundation insulation. Clearance is clearance is clearance I guess?
It may only be 20mm think. But the cuboid cave is insulated on the walls. Yay. Now I'm hoping for some cooler weather to get the muck on. Until then, time for some electrics.
It's too hot to render.
Can't roof until walls are finished.
So it's time to start electrics.
So far trunking is in (few more fixings needed) and I've started routing the light conduit.
Conduit in piers all mostly line up with the metalclad... Mostly
Couple of cable outlets to add for the tools and the CU needed, then can get the reels out.
Can't roof until walls are finished.
So it's time to start electrics.
So far trunking is in (few more fixings needed) and I've started routing the light conduit.
Conduit in piers all mostly line up with the metalclad... Mostly
Couple of cable outlets to add for the tools and the CU needed, then can get the reels out.
Anyone else find first fix oddly satisfying?
Let there be light!
I'm a big fan of this
It's all wired back to a single flex on an IEC plug
And the ring is in. It's been a long time as a building site, then a cave, but finally it feels like a building.
I'm a big fan of this
It's all wired back to a single flex on an IEC plug
And the ring is in. It's been a long time as a building site, then a cave, but finally it feels like a building.
Looks fantastic.
Possible suggestion. I put an emergency light (connected to light circuit) in my windowless workshop. Decided that if I tripped the lights, with saw still on, and floor covered in trip hazards, I wanted to be able to see route out and where door handle is.
Possible suggestion. I put an emergency light (connected to light circuit) in my windowless workshop. Decided that if I tripped the lights, with saw still on, and floor covered in trip hazards, I wanted to be able to see route out and where door handle is.
Last edited:
Oh crack!
This isn't good...
This isn't good...
Is that the floor?
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
