I doubt that (m)any people have. However, I also doubt that many will have seen "DIYers" (or 'electricians' of questionable competence/sense!) 'fiddling around injudiciously inside 3-phase DBs (when have ones fiddling fingers surrounded by earthed metal becomes a hazard)!
Advice on EICR failure C2
- Thread starter TonyWarrington
- Start date
- Joined
- 27 Jan 2008
- Messages
- 28,145
- Reaction score
- 3,414
- Location
- Llanfair Caereinion, Nr Welshpool
- Country
1980 Siemens with bottle fuses used in Algeria, where the switch was after the fuse, so fuse always changed live. Clear plastic so you could see any faults without opening the board.
Once also common in Germany too.
- Joined
- 27 Jan 2008
- Messages
- 28,145
- Reaction score
- 3,414
- Location
- Llanfair Caereinion, Nr Welshpool
- Country
It was a Dutch firm. NACAP BV.
Very much a Berlin company, IIRC Siemenns & Halsk started the company mid 19th century in a tenament building where they created and manufactured a telegraph receiver.
We were shown the building surrounding an open area, like a little garden/car park/quadrangle behind a butchers and bakers shops (sorry no candlestick maker), (I think on or close to Charlottenstrasse) on a guided tour in 1977 but I'm not sure if it was where the company was based or Siemens lived.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
