Search results

i have removed some tiles from the ceiling any ideas how to get the adhesive off the ceiling

hi guys need to take off a radiator with a danfoss thermostatic radiator valve what s the best way to shut off the valve and take off the radiator

hi guys i have got a house to remove paper from walls and ceilings approximatley 15/20 years old i have to pull off the first layer and then get onto brown backing paper its all the one paper steamer wont remove unless i peel back the finish part of the paper any ideas on whats the fastest way...

thanks for all your help lads got a gas engineer onto it it was the motherboard

they are any ideas were id get the user manual

i want to open up my kitchen its a single skin of brickwork 11 foot long above a non load bearing wall its 12 inches away from the wall above how much would you suggest either side of the rsj and would i get away with a timber beam or something liter cheers for any ideas

having problems starting boiler its a worcester 9/14 cbi its starts the flame for two seconds then stops the fault light then comes on flashes according to manual it means "flame failure" this boiler has not been started for a while as i have just bought the house it is a vented system not...

hi guys just bought a house moving in saturday cannot get the boiler to work power supply on took cover off no ignition light on but gas is on system has no tanks just cws cistern has cooper cylinder with switch any ideas how to get the boiler working its a worcester 9/14,14/19,19/24 cbi that...

yeah the tap works fine when its on three quaters of the way

thanks for the reply the water is cold untill the tap has been three quaters of the way

hi i have got a combi boiler works fine only one thing to get the hot tap in the bathroom and kitchen to run hot it needs to be turned on three quaters of the way otherwise its cold any ideas cheers richard

hi i was wondering whats the best way to join the old imperial pipes half inch to the newer metric 15mm when fitting sinks and baths richard

hi guys how will i know what size cable i have going into my electric shower

hi firstly let it dry out then push the ceiling and if it needs replacing it will youll see screw holes coming through also look out for bows or uneven lines were the wall meets the ceiling the weakest part will be were the light is

id say stone or sand the roughness and use the trowel if your right handed youll be ok wont be so bad and use the back end of the trowel for those corners

it was good to see the door open my advice not the wright one for the job at the mo thanks for pointing it out cranc

hi you can buy a trowel that is used on marble plastering has a standard handle its 75mm wide id patten it out let the battens meet in the corners would grip fill them on thats if ya have the thickness

hi get the skim as good as poss then put some on the tip pull it all the way down let it dry in dont panic itll keep even if its nearly gone leave it then trowel up on second trowel pull it down again

hi id say that they have cut out that part of the lock which is a spring loaded latch there will be a thumb turn or a key this is what will open the door turn it anti clockwise to open sometimes they will turn but wont open this is a problem with the barrel let me know what happens and i can...

hi id say use fibre tape its self adhesive thinner and lighter mainly cracks come from shrinkage