Search results

  1. G

    How to tighten toilet seat on this pan?!!

    Hi, I have been asked to tighten up a loose toilet seat but I do have a clue how to do it on this type of pan. Can somebody give me some instructions please? Picture attached N
  2. G

    Mira Essentials on/off switch not releasing when cover on

    Hi, I have just fitted a replacement heater unit to a mira essentials electric shower and a new cover (old one had been ripped off a few times by the looks of it). Everything appears to be sitting back properly etc.. I have a strange issue with the on/off button only when the front cover...
  3. G

    Fan oven motor insulation

    I have just fitted a new fan oven motor to my hotpoint double oven, a BD31. The new one was almost identical to the old except that it had a fan on both sides; on on the motor and the other inside the oven. I purchased the new fan from partmaster where some fans motor descriptions...
  4. G

    Can this handle be repaired or replaced?

    Hi all, I have one broken handle and one good one on the window. I have the broken off bits. Pictures attached. Are window handles like these a standard size/fit? Can this type of handle be replaced or repaired? Thanks
  5. G

    fitting fluidmaster cable flush valve to a low level cistern

    Hi, Can I fit a fluidmaster cable flush valve to a low level cistern to replace a normal siphon valve? If so, would any cable flush operated flush valve fit on a low level cistern or does it have to a an adapter with it? Thanks. Nigel T
  6. G

    Best way to tidy up kitchen worktop in situ and no power

    Hi, I have been asked by a letting agent to tidy up some work that a tenant has performed on a kitchen worktop end. Typically it was done by a man in a rush so the jigsaw cut waving all over the place, face edge looks OK. There is no power in the property so I thought I could tidy it up...
  7. G

    uPVC door. Is there any adjustment possible here?

    I have a customer with a door that does not close properly and the bottom bolt, when unlocked, catches its keep situated on the bottom of the frame. The catch does not enter the keep at all, too far away but it is lined up. The bottom bolt loosely hangs out of the bottom which also catches...
  8. G

    Adjustment of uPVC windows and doors

    Hi, I have been asked to see if I can reduce the gap on only the hinge side of the window shown in the images. I have looked at previous posts which leads me to believe that I need to replace the hinges or the windows. Is this correct, should I replace them? Or should I attempt to free...
  9. G

    redundant cistern overflow - making good

    Hi, I have replaced my flush valve with one that has an internal overflow. Can somebody give me an idea on how to make good the old overflow pipework? Should I cut it flush with the internal wall and fill it? Should I remove it completely and make good inside and outside or is there a...
  10. G

    Pump not pumping in the same direction as the flow arrow

    Hi all, I had turned my CH pump down from setting 3 to setting 2 a while ago in an attempt to make life a bit quieter. It did the trick. However, when it is set to setting 3 it rotates in the correct direction, when on either 2 or 1 it rotates in the wrong direction. The heating is...
  11. G

    Y plan system with no room thermostat

    Hi, Can anybody tell me if a not having a room stat in a Y-plan system will cause premature failure of a mid-position valve on a system fitted with TRVs on most radiators? I realise that the boiler will be on a lot more than without it. What will be the effect on the system? Cheers
  12. G

    Pump shower Galaxy G2000LX leaking

    Hi, A customer has a leak between the flow valve and the inlet. Does anybody know if the seal can be replaced without buying a new flow valve? Thanks
Back
Top