I am going to install a 3-pin socket to power my new inverter welder which hasn't arrived yet. I noticed that there are 16a and 32a 3-pin sockets available.
I think its wise to install the 32a socket on a 32a MCB. Now a guy today told me that if my welder came with a 16a plug, it won't fit the 32a socket. I haven't looked at these industrial socket in the flesh but I think thats a load of balls? One is rated higher than the other but both fit without problems?
Also, the run from the CU to the new socket is about 5m max and I will install it in conduit. Is 6mm correct for this or will 4mm be fine?
Can you get outdoor industrial 3-pin sockets?
Cheers.
I think its wise to install the 32a socket on a 32a MCB. Now a guy today told me that if my welder came with a 16a plug, it won't fit the 32a socket. I haven't looked at these industrial socket in the flesh but I think thats a load of balls? One is rated higher than the other but both fit without problems?
Also, the run from the CU to the new socket is about 5m max and I will install it in conduit. Is 6mm correct for this or will 4mm be fine?
Can you get outdoor industrial 3-pin sockets?
Cheers.