Hi, does anyone know if there is a gadget that can join my loops together? I am changing MR16 downlights to GU10 so there are 4 wires into the transformer and 2 out to the light.
I have squeezed the 2 same colour wires into the same connector and tested. All fine. When I push them back into the roof one of the wires in the group of 6 lights comes loose and they all stop working except 1. I could take them all out again and tighten them all up (again) but I suspect when I push them up, the same will happen again. Any suggestions greatly appreciated! I had the same problem with the other lights I changed but as there were only 3, I just took them all out and re-did them (again and again!).
I have squeezed the 2 same colour wires into the same connector and tested. All fine. When I push them back into the roof one of the wires in the group of 6 lights comes loose and they all stop working except 1. I could take them all out again and tighten them all up (again) but I suspect when I push them up, the same will happen again. Any suggestions greatly appreciated! I had the same problem with the other lights I changed but as there were only 3, I just took them all out and re-did them (again and again!).