45 Degree Tile Chamfering Tool for Angle Grinder

[Yukster]

I'd be grateful for a recommendation for

1. a good 45 Degree Tile Chamfering Tool for Angle Grinder. I've seen a few on Amazon but the reviews are not good. Can someone recommend one that works well please.

2. Good angle grinder that's got enough power to cut 3cm terracotta tiles

TIA

 

[ree]

OP,
Depending on what you are intending to do but its often best to hire a professional wet tile saw for cutting chamfering and mitering 30mm material.

 

[StephenStephen]

I just used a bog standard wet tile cutter for chamfering slate tiles.

Are these tiles 3cm deep?

 

[Yukster]

I think my original question was a bit confusing. What I'm trying to do is finish the edge of a path that's looking a bit rough.

The tiles are actually 22mm thick and my idea was to cut the end of the path tiles at 45 degrees, and to use leftover tile also cut at 45 degrees to cover the ugly concrete bit in the pic, hence my question about the grinder attachment.

Is this doable, a sensible idea?

 

[opps]

If I understand what you want want to do, you would need to remove the existing end tiles and chamfer them.

Wouldn't it be easier to find a black tie of a suitable height and then trim it to height?