Hi, could anyone help me please? I was tiling a bathroom at a customers house today. I had to remove a panic button from by the door as the cables ran into the downstairs loo and the customer wanted it removed.
I accidentaly triggered the alarm. We was able to turn the alarm off by releasing the button and coding the keypad. (no chimes from pad tho)
Now i have disconnected the switch completely, left red and black taped up together ( they were in a connector in the switch) and isolated the trigger wires.
The problem i have is that the bell strobe just keeps flashing, and the keypad is non responsive. I have isolated power, disconnected 17 and 27 iirc and linked them together to force a non volatile reset. Strobe stops flashing but the key pad wont allow us to set/reset etc. It will allow us to silence the alarm if its triggered tho.
Reconnnect wires to 17 and 27 and im back to square one.
Any help would be much appreciated. Need to hand over tomorrow.
Cheers Gareth
I accidentaly triggered the alarm. We was able to turn the alarm off by releasing the button and coding the keypad. (no chimes from pad tho)
Now i have disconnected the switch completely, left red and black taped up together ( they were in a connector in the switch) and isolated the trigger wires.
The problem i have is that the bell strobe just keeps flashing, and the keypad is non responsive. I have isolated power, disconnected 17 and 27 iirc and linked them together to force a non volatile reset. Strobe stops flashing but the key pad wont allow us to set/reset etc. It will allow us to silence the alarm if its triggered tho.
Reconnnect wires to 17 and 27 and im back to square one.
Any help would be much appreciated. Need to hand over tomorrow.
Cheers Gareth