Our immersion heater has been removed and I have switched off the MCB and terminated the insulated wires in "chocolate block". Please can someone tell me how to remove the MCB from this Ashley Rock CU circa 1996 as I want to make things as safe as possible?.
Ashley Rock Consumer Unit
- Thread starter Pete1948
- Start date
Sponsored Links
Just remove the cable from the immersion heater switch or change it to a socket.
No point removing the MCB.
No point removing the MCB.
- Joined
- 11 Jan 2004
- Messages
- 42,733
- Reaction score
- 2,633
- Country
If you desperately want to remove something from the CU, disconnect the cabling from the CU and remove the cable.
But, as EFLI points out, it may be useful as a socket instead.
But, as EFLI points out, it may be useful as a socket instead.
Removng an MCB in many CUs means taking the busbar out to free up the MCB. Not something to do unless you are familiar with consumer units and the risks involved.
And then you'll have a gap in the front of the board and exposed live parts.
Then you'll need to buy a blanking plate.....
Leave that MCB in place. Its not doing any harm.
And then you'll have a gap in the front of the board and exposed live parts.
Then you'll need to buy a blanking plate.....
Leave that MCB in place. Its not doing any harm.
Sponsored Links
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
