Bath mixer tap cartridge doesn't go in

Joined
10 Oct 2019
Messages
230
Reaction score
15
Country
United Kingdom
Hi There

I had a plumber in a few days ago to fix something else and he offered to fit a new cartridge on our mixer tap. Unfortunately he couldn't get his cartridge to fit and made a swift exit:giggle:.

I went and bought a new 40 mm cartridge myself with same dimensions as the old one but I can't get it all the way into the hole which is really odd as the old one slides in with no trouble. There's a brass ring of sorts at the bottom of the mixer tap and I can't get it past that it seems.

I could buy a new mixer tap but don't really fancy spending extra money as we'll probably refurbish the bathroom at some point.

Is this a common issue?
Any ideas how I get this fixed without buying a new tap?

Many thanks
 
have a close look right down inside the housing with a torch mate, dollars to donuts the old rubber seal or an o-ring from the original cartridge detached and is still sat wedged at the bottom. also check the two little locating lugs on the base of the new cartridge, on some aftermarket 40mm ones they’re fractionally wider than original ceramic discs and need a tiny scrape with a stanley blade to drop into the brass recess holes properly. wipe a smear of silicone grease around the barrel and it should push right home once that bottom ring is clear.
 
have a close look right down inside the housing with a torch mate, dollars to donuts the old rubber seal or an o-ring from the original cartridge detached and is still sat wedged at the bottom. also check the two little locating lugs on the base of the new cartridge, on some aftermarket 40mm ones they’re fractionally wider than original ceramic discs and need a tiny scrape with a stanley blade to drop into the brass recess holes properly. wipe a smear of silicone grease around the barrel and it should push right home once that bottom ring is clear.
Thanks for this. Still can't get it in. Upon closer inspection I think the new cartridge is possibly 1 mm (maybe 2 mm) wider than the hole. I may take the mixer down to a plumbing shop to see what they can rustle up.
 
Can you provide some photos?
Sure. See attached. Image 1 and 2 is the mixer tap and image 3 is the cartridge which goes in ok but not past that metal ring at the bottom.
 

Attachments

  • IMG_2422.jpeg
    IMG_2422.jpeg
    625.8 KB · Views: 7
  • IMG_2421.jpeg
    IMG_2421.jpeg
    727.4 KB · Views: 7
  • IMG_2423.jpeg
    IMG_2423.jpeg
    774.6 KB · Views: 8
There's a metal ring at the bottom for stability (I assume). Difficult to measure but not impossible it's a tad more narrow.
Sorry, that’s not what I meant. Can you post a photo of the base of the cartridge?
 

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top