Same trowel will do.
Bear in mind that those mosaic tiles tend to sink easily, so go easy pushing them in.
I usually rest them against the adhesive and then push them in with a spirit level.
Same trowel will do.
Bear in mind that those mosaic tiles tend to sink easily, so go easy pushing them in.
I usually rest them against the adhesive and then push them in with a spirit level.
Some of the adhesive might leak through, but if the mix is correct, it shouldn't.
Get a scale and weight water and adhesive powder as per manufacturer's instructions.
I prefer to rely on a scale rather than my eyes and I get a consistent mix every time.
Little tip: unless you're a fast tiler, get the slow curing adhesive (3hours with 60/90 minutes pot time) and a clean tub with lid to keep the adhesive in between tiles.
Empty 15 litre paint pots are perfect.
Having it skimmed, will put plastic sheeting over to cover the tiles while its done. Any views on the Mosiac tile backer? Or where you whould start the first tile ont he wall pictured?
Thanks
I was not sure if I should start a new thread or just piggy back on this one.
I am about to replace the floor tiles in our bathroom. We have a couple of loose tile as well as broken ones. I Lifted one up and noticed that they had used cement based adhesive on top of the floorboard.
Do I need to unscrew & cutt off the existing plasterboard for replacement or just try to lift the tiles and adhesive off?
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local