Hi,
I've been asked to 1st fix a conservatory. Which of the following ways (if any) would you consider the best way to do it.
Conservatory needs 4 sockets, 1 on one wall, 3 on another after patio doors.
I was going to run radial circuit in 4mm 3core SWA(from front of house round outside to consrvatory(RCD'd at CU)) to the outside wall of 1st socket, 4mm t/e into back box, via conny block in outside box. Back then along the outside of conservatory under patio doors to outside 2nd socket (in 4mm swa). Enter 2nd sockets in 4mmt/e, then go to the other sockets on that wall either:
Via cavity - which is full tight with insulation now.
or
in capping horizontal to each socket (though theres a 30 degree bend in wall and was concerned about when the plasterers dryline the corner of the wall.
Which way is best, or would you do it another way
Thanks
I've been asked to 1st fix a conservatory. Which of the following ways (if any) would you consider the best way to do it.
Conservatory needs 4 sockets, 1 on one wall, 3 on another after patio doors.
I was going to run radial circuit in 4mm 3core SWA(from front of house round outside to consrvatory(RCD'd at CU)) to the outside wall of 1st socket, 4mm t/e into back box, via conny block in outside box. Back then along the outside of conservatory under patio doors to outside 2nd socket (in 4mm swa). Enter 2nd sockets in 4mmt/e, then go to the other sockets on that wall either:
Via cavity - which is full tight with insulation now.
or
in capping horizontal to each socket (though theres a 30 degree bend in wall and was concerned about when the plasterers dryline the corner of the wall.
Which way is best, or would you do it another way
Thanks