I have 2 panic buttons in series back to the Panel, I do have a spare zone on the expander but have them earmarked for later additions to out buildings. I also have used OP1 for internal sounder (sounding 1 minute in advance of outside bell) and have OP2 earmarked (please see further Q2 below) for a external Klaxon Siren www.klaxonsignals.com/industrial&WAS/productDetails.asp?productID=52&categoryID=49
Q1. Is it bad practice to series wire the panic into the (any?) tamper circuit?
Q2. The Klaxon is 12V relayed, would it be OK to wire this from the Bell +,- outputs from the panel (rather than using OP2)?
Looking forward hopefully to the high quality answers and help recieved so far - thanks in anticipation.
Q1. Is it bad practice to series wire the panic into the (any?) tamper circuit?
Q2. The Klaxon is 12V relayed, would it be OK to wire this from the Bell +,- outputs from the panel (rather than using OP2)?
Looking forward hopefully to the high quality answers and help recieved so far - thanks in anticipation.