Hi all, I hope someone can assist with the following issue.
Due to having a new carpet fitted etc, I decided to remove a door for trimming, and at the same time fit new hinges etc as the door has never fitted well and always blinded at the hinge side and sprung open. I did pack out the old hinges to improve matters, but decided to fit new ones and recut the hinges on both the door and hinge on the frame. I cut btoth sets off hinge rebates dso the hinges were flush with the surface on both the frame and dc door in new positions. But the door is still binding. The door sits out of square with a larger gap at the top of the door srtop than at the bottom. The hinge leafs are 20mm and are on a bb hinge.
If anyone can assist I would be very grateful.
Due to having a new carpet fitted etc, I decided to remove a door for trimming, and at the same time fit new hinges etc as the door has never fitted well and always blinded at the hinge side and sprung open. I did pack out the old hinges to improve matters, but decided to fit new ones and recut the hinges on both the door and hinge on the frame. I cut btoth sets off hinge rebates dso the hinges were flush with the surface on both the frame and dc door in new positions. But the door is still binding. The door sits out of square with a larger gap at the top of the door srtop than at the bottom. The hinge leafs are 20mm and are on a bb hinge.
If anyone can assist I would be very grateful.
