- Joined
- 5 Dec 2012
- Messages
- 927
- Reaction score
- 13
- Country
I've installed a row of cabinets, of which I started on the middle of the chimney breast rather than the corner, as the oven has to be central in chimney hence starting there.
To ensure that all cabinet doors are flush, the distance from wall to front of cabinet is 59.5cm at the corner end, and 58.5cm the far end (had to pull units from wall slightly to make flush)
I haven't installed the corner unit yet(I tegrsted dishwasher) but I've put a set square against the front face (blanking panel) of corner unit, and it's not 100% square with the xlal where the next run will be. To exagerate, the set square 'points' back into the room,.
How do I deal with this when installed next run (from corner I will be having a 600mm integrated washing machine, 1000mm sink units and at the end, an Integrated dishwasher at the end.
Would this mean that my end panel won't fit properly at the end of the washing machine?
Thanks.
To ensure that all cabinet doors are flush, the distance from wall to front of cabinet is 59.5cm at the corner end, and 58.5cm the far end (had to pull units from wall slightly to make flush)
I haven't installed the corner unit yet(I tegrsted dishwasher) but I've put a set square against the front face (blanking panel) of corner unit, and it's not 100% square with the xlal where the next run will be. To exagerate, the set square 'points' back into the room,.
How do I deal with this when installed next run (from corner I will be having a 600mm integrated washing machine, 1000mm sink units and at the end, an Integrated dishwasher at the end.
Would this mean that my end panel won't fit properly at the end of the washing machine?
Thanks.