10 years ago I caught the 2.5mm flex to a light when I was plying the floor of the bathroom before tiling. I just taped the wire up with pvc tap. Currently the ceiling is down the the kitchen and wonderd if there is a better repair I could/would do on this while the ceiling is down. Thanks!
Caught wire with screw
- Thread starter Fallout
- Start date
Sponsored Links
A proper joint in a suitable joint box, or it may be easier to simply replace the cable end to end and not use a joint. The type of joint you can use, depends upon whether the joint will be accessible for inspection later on. Likely it will be 1.5mm, rather than 2.5mm.
Someone will along in moment, to explain the the none accessible joint options.
Sponsored Links
Do you mean, you did not actually break the core of a wire?
Just put an empty joint box around the cable without cutting the cores. If the damage to a conductor is severe, cut and joint that core, an ideal through connector would be ideal.
Yes has just damaged the sheathing
If the insulation of the actual wire cores is undamaged, just the (usually) grey sheath nicked, then I would just apply a few layers of electrical tape.
If you haven't damaged the insulation around the wire anything you put round the cable is just aesthetic and serves no real purpose other than letting you think you have done something to make it safer
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
