CH inhibitor test strips - worth it ?

Joined
27 Jul 2006
Messages
560
Reaction score
10
Country
United Kingdom
Hi all,

I was just wondering what everyone's thoughts are on the inhibitor test strips to test strength
You may recall i did a clean of my system which took ages to flush, mainly due to me overdosing with cleaner but i eventually did it with guidance from this forum, but i would now like to just take a sample and test

Are they any good as they seem pretty expensive, particularly for a DIYer ?
Also, are they generic or do you need to use the Adey test strips if you've used the Adey inhibitor ?

I'm due to have my boiler serviced so will ask my engineer too but i'm interested all the same

TIA
 
Try this free test. Drain a drop of your central heating fluid into a container. In another container, put the same amount of tap water. Drop a bright steel nail into both containers. After a couple of days, have a look at them. You’ll soon know whether you have enough corrosion inhibitor in the system.

Here’s mine after about 4 days. Tap water on the left. Mind you, the system water on the right may be due for a top up. I put my inhibitor in 9 years ago when the new boiler was installed and I’ve changed a few rads and done the odd top up since then - it’s starting to look a bit discoloured and it’s normally gin clear.

IMG_5096.jpeg
 
Last edited:
honestly mate for a diyer they're a waste of money, you're looking at £25 for strips when a fresh bottle of fernox f1 or sentinel x100 is half that. if you've flushed it properly just tip a full bottle straight in for peace of mind, you can't really overdose modern inhibitor anyway. most gas engineers carry dropper test kits on the van and check it on the annual boiler service as standard.
 
cheers @Mottie @wazzheed

I'll see if my engineer carries them and ask if he can do a test during the service

Interesting about not being able to overdose the system
When i was preparing to add the inhibitor, i engaged the Adey tech support team and asked about double dosing and they specifically said not to, although didn't give a reason
 
cheers @Mottie @wazzheed

I'll see if my engineer carries them and ask if he can do a test during the service

Interesting about not being able to overdose the system
When i was preparing to add the inhibitor, i engaged the Adey tech support team and asked about double dosing and they specifically said not to, although didn't give a reason
no worries mate, adey probably just cover their backs so people don't turn their system water into pure syrup haha. standard 500ml bottle is formulated for around a 100 litre system (roughly 10 rads), so even in a smaller house one whole bottle is sound. definitely worth getting your bloke to test it when he services the boiler though, saves you buying a full kit.
 

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top