Hi, I need to replace the temp sensor and the overheat thermo which are located within the combustion chamber on my cb24x. I have removed the cover screws and found it difficult to remove the cover, I didn't want to force it, anything I need to know? Also do I need to repressurise the system other than with the mains inlet? Cheers.
combustion chamber on alpha cb24x
- Thread starter macca71
- Start date
Yes, you need to know you shouldnt remove the CC cover unless you know how to check it correctly afterwards.
dont
- Joined
- 30 Oct 2006
- Messages
- 6,754
- Reaction score
- 386
- Country
had one like this a few months ago. ALL the CC seals fell apart when the cover finally came off. Boiler not safe to use therefore until I got new seals.
thats happened to me once as well. poor design with the seals going right down the side, rips them off over time.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
