I have just bought an Axis Mixer Shower set with concealed valve from B &Q.
The shower head is on an adjustable riser rail, and i would normally expect to locate the wall union elbow directly below the valve controls. HOWEVER, the outlet for the valve heads upwards (as if to a built in shower head).
The instructions say that the "valve does not allow the facility to change the position of the water outlet. The water outlet must always remain at the top of the valve". Is there anyway of solving this other than doing a maze of short pipework and elbows to get the water heading back down below the valve?
Any help is greatly appreciated, cheers.
The shower head is on an adjustable riser rail, and i would normally expect to locate the wall union elbow directly below the valve controls. HOWEVER, the outlet for the valve heads upwards (as if to a built in shower head).
The instructions say that the "valve does not allow the facility to change the position of the water outlet. The water outlet must always remain at the top of the valve". Is there anyway of solving this other than doing a maze of short pipework and elbows to get the water heading back down below the valve?
Any help is greatly appreciated, cheers.