I currently have a B & Q light fitting which switches on at low wattage when it becomes dark, and brightens to full capacity when someone activates the PIR sensor that is built into the unit.
I now wish to remove this unit, and install 4 no 100 watt bulkhead style light fittings, operated by 2 no independent PIR sensors and an over-ride switch, the PIR's of which will operate in the same manner as the B & Q light; in other words, when it is dusk all 4 lights operate at low wattage, and when either of the 2 pir units are activated all four lights operate at maximum brightness for a set time. Or the PIR can be over-ridden with a manual by-pass switch.
Can anyone advise as to how I can achieve this, and if so, what hardware is required?
I now wish to remove this unit, and install 4 no 100 watt bulkhead style light fittings, operated by 2 no independent PIR sensors and an over-ride switch, the PIR's of which will operate in the same manner as the B & Q light; in other words, when it is dusk all 4 lights operate at low wattage, and when either of the 2 pir units are activated all four lights operate at maximum brightness for a set time. Or the PIR can be over-ridden with a manual by-pass switch.
Can anyone advise as to how I can achieve this, and if so, what hardware is required?