Does thermostat in coldest area make sense?

A condensing boiler keeps the flue gases cool enough so the water in the gas condenses, to do that it can use two methods, one is modulate which means turning down output, the other is to use a mark/space ratio, the space getting longer and the mark getting shorter and it does this once the boiler is already at minium output.

This is why it is so important for the boiler to be correctly sized, my home is three story and has a 20 kW boiler, I hear the boiler turning on/off so clearly it is large enough, which asks the question why so many homes have 35 kW boilers?

But what we are looking at is not the maximum output, but the minium output, and some makes of 35 kW boilers can modulate to a lower output to other makes with a 25 kW boiler.

Before the hour was taken off, I was using a 2 kW oil filled radiator to heat our main room which was ample, but electric cost more than oil, and once we went the UTC my solar was not enough to run the oil filled radiator, so switched to central heating, but the point is at the start of the season 2 kW was enough.

Hardly any boiler will turn down that low, so it has to use a mark/space ratio. But when using analogue control it turns back on at minium output, but with digital (on/off) it turns back on in the main at maximum output.

There is no reason why a boiler should not be programmed to turn back on at minium, and it is possible today some boilers will, restart at minium. If I was programming it I would do just that, but I am not a heating and ventilation engineer, I wrote programs to run concrete batching plants, candle making plants, etc, but not a boiler, which likely uses a PIC rather than a PLC and I was never very good writing PIC programs.
 
Radiators used to be sized to room temperatures, 16⁰C in a hall or bedroom,18 kitchen and bathroom, 21 living dining rooms when the flow temp was set to give a 75⁰C flow and a 10 or 12⁰C ∆T.

Although the F&R are different now and kids doing homework in bedrooms kept to higher temps the hall hasn't changed and is more representative than a lounge with the door shut and stationary people each giving off 200W or more affecting the room stat when placed there.

Flow rate through radiators can be balanced on the lock shield valve or in the case of the lounge, a TRV to give the required temperatures on a room by room basis with the hall representing a constant fitted with lock shield valves.

Having said that, it's your house, do what you think best and don't be afraid to adjust to suit your own requirements.
 
This gives a idea of what happens with reducing flow temperature only after setting to 75C flow, 10C dT.

1795367675517.png
 

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top