Flexi tap tails for Ikea monobloc tap

[StudioAB]

Hello all,

I am about to fit an Ikea 'Loviken' monobloc kitchen tap.

It comes supplied with rigid copper tails but I would like to replace these with flexi tap tails instead (due to my existing pipe layout).

I have found some flexi tap tails for monobloc taps at Screwfix.com but there are two sizes to choose from – 10mm x 15mm x 300mm OR 12mm x 15mm x 300mm. Can anyone explain what this 10/12mm size difference is and which one would suit me best? Also, what would be the best way to fit an isolating valve to both tails?

Thanks in advance!

 

[swidders]

the 10 or 12 mm indicates the size of the bit that actually screws into the tap. As to which one - take a copper tail with you to a plumbers merchant or DIY store to compare.

Easiest way to fit isolators will be to use a short offcut from your supplied tails to bridge between the end of the flexi and the isolator valve