- Joined
- 19 Mar 2007
- Messages
- 692
- Reaction score
- 5
- Country
put a sink in my worktop today...cut the hole perfectly with my jigsaw..read instructions several times before i took on the job...anyway i measured around the sink as per instructions..then it said measue 10mm in from the outline i made for the sink..done that...cut out the hole and now its just about rest about 3mm allround the worktop...WTF...i thought....any solution or advise...?..i was thinking of putting some battons around the cut ie around 8mm x 25mm to reduce the gap...what you guiys think ?...in the instructions it said "10mm (2/4").... ???????..which 2/4" is the same as half inch...12.5mm,...just as well i didnt go the 12.5mm..as the sink would have dropped through..