Hi all (please ignore I double posted by mistake).
Gloworm Ultimate pcb 105111
Pilot flame on boiler won't light.
I have checked the two fuses on the pcb - both ok.
When 240V switched on the two leds on pcb flash momentarily then go out and a relay on the pcb picks up. Relay stays in until 240V switched off.
Question is shouldn't the leds stay lit? If so does this mean pcb is faulty?
ta very much.
ian
Gloworm Ultimate pcb 105111
Pilot flame on boiler won't light.
I have checked the two fuses on the pcb - both ok.
When 240V switched on the two leds on pcb flash momentarily then go out and a relay on the pcb picks up. Relay stays in until 240V switched off.
Question is shouldn't the leds stay lit? If so does this mean pcb is faulty?
ta very much.
ian