Check out this at about 11mins in when he opens the three phase switches and they are intended to be wired with chocblock and it looks like 15A or smaller.
Good old chocblock !
- Thread starter Sureitsoff?
- Start date
Connects to the RCD with it in the on position. Probably isolated elsewhere but should still be in the off position.
Torque settings - whale on it until it can take no more.
Wire management - cram it and ram it.
Torque settings - whale on it until it can take no more.
Wire management - cram it and ram it.
That looks pretty decent by some standards! 
Why such long lengths of sleeving? Shorter lengths of a smaller diameter, (or even heat shrunk into place), would have looked so much neater.
When we were taught to wire up DB boards, we put the neutral and earth in a corresponding position the live. Makes things so much easier, and quicker, to trace all same circuit cables.
Good luck with trying to quickly find neutral and earth when trying to completely disconnect a circuit with that lot.
When we were taught to wire up DB boards, we put the neutral and earth in a corresponding position the live. Makes things so much easier, and quicker, to trace all same circuit cables.
Good luck with trying to quickly find neutral and earth when trying to completely disconnect a circuit with that lot.
- Joined
- 13 Mar 2019
- Messages
- 1,257
- Reaction score
- 317
- Country
Those flipflops are VDE-rated so he'll be absolutely fine.That looks pretty decent by some standards!
More to the point, why are there chocblocs there in the first place?
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
