I was drilling holes in kitchen cabinet. The drill slipped and there's a graze on a water pipe(15mm copper pipe). The grace caused a sharp bit on pipe however it's not leaking and I wanted to know if I should just leave it or do anything
....turn it in FFS.Rub it down so you smooth out the rough spots, put some solder on it, then wipe a piece of moleskin over it.
So you've wiped underhand/rolled/knuckle/branch joints without the use of plumbers black??No idea what plumbers black is, but I do have a piece of moleskin (somewhere) that I used to wipe lead joints with - God, that was years ago.
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local