29 Sep 2019
Reaction score
United Kingdom
Looking for some advice? Installing a Hive Multizone in a property. It has the Danfoss programmer. See attached wiring for it; Would I wire this like for like as per the Hives instructions and just remove and cap the remote sensor. See attached photo? Then would I get the single channel receiver for the Multizone and wire that in to the programmable room stat? Obviously would put it up into the Cylinder room And give it a neutral wire. Again see photos. Not sure if this makes sense? Would highly appreciate any advice.

Sponsored Links

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.

Are you a trade or supplier? You can create your listing free at DIYnot Local

Sponsored Links