- Joined
- 29 Sep 2019
- Messages
- 2
- Reaction score
- 0
- Country
Looking for some advice? Installing a Hive Multizone in a property. It has the Danfoss programmer. See attached wiring for it; Would I wire this like for like as per the Hives instructions and just remove and cap the remote sensor. See attached photo? Then would I get the single channel receiver for the Multizone and wire that in to the programmable room stat? Obviously would put it up into the Cylinder room And give it a neutral wire. Again see photos. Not sure if this makes sense? Would highly appreciate any advice.