I have a dual channel hive programmer to install. Currently have a corgi programmer with wiring below
There is no heating off wire which would go into terminal 5. I read on another thread that Hive didn't necessarily need that...is that correct? I couldn't find anything which covered that for sure on any other thread.
I also have a wired thermostat which I am planning to bridge out, if that makes any difference.
So can I connect up without "heating off" wire?
Thanks
There is no heating off wire which would go into terminal 5. I read on another thread that Hive didn't necessarily need that...is that correct? I couldn't find anything which covered that for sure on any other thread.
I also have a wired thermostat which I am planning to bridge out, if that makes any difference.
So can I connect up without "heating off" wire?
Thanks